Atmel CAMELIA 8M Manual de usuario Pagina 1

1 5319C–IMAGE–02/04Main Features• High Sensitivity Full-frame CCD Sensor • 2300 x 3500 Resolution with 10 µm Square Pixels• 100% Aperture Pixels • 12-

10CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Gain and Offset The video gain and offset signal processing can be adjusted by setting th

11CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/043-Shot Color Operation In 3-shot color mode, each image is made up of 3 frames: red, gree

12CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Serial CommunicationSerial Configuration The camera configuration is set by an RS-232 or

13CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Note: ROI commands have been available since October 2001 starting with the cameraS/N: 01

14CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Command Syntax • The valid syntax is: S=n(CR) where:– S: command identification (S is a s

15CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Storing the Current ConfigurationWhen the camera receives !=4(CR) it stores the current c

16CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Timing 2 x 2 and 4 x 4 pixel binning can be used to enable previewing modes. The previewm

17CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Continuous: T=0 The camera delivers frames continuously:• Frame N+1 integration starts as

18CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Operation with Integration Time Control: T=2The integration is fully controlled by the us

19CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04CameraLink Camera TimingThree timing modes are available: continuous, external triggered

2CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Improvements The Camelia 8M has been redesigned to:• Add new features, which include:– Gai

20CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Operation with External Trigger: T=1The start of integration is controlled by the user wi

21CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Line Timing • The PCK’s duty cycle is 50%• The PCK’s clock rate is 25 MHz• The data rate

22CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Electrical InterfacesDATA, SYNC and TTL CONTROL for LVDS CamerasNote: 1. LVDS (Low Voltag

23CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04• Receiver: DS90LVO48ATMTC (SO16 package)DATA & SYNC Cabling 50-pin connector:• Conne

24CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04TTL CONTROL Cabling The connector on the camera is a D-sub 9-pin male connector.Notes: 1.

25CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04CAMERALINK and TTL CONTROL for CameraLink CameraNotes: 1. TRIG_ITC signal is connected on

26CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/045. LVDS (Low Voltage Differential Signal): EIA 644 standardAll digital I/Os are different

27CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04TTL CONTROL Cabling The connector on the camera is a D-sub 9-pin male connector.Notes: 1.

28CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04RS-232 for LVDS Camera • On camera side: D-sub 9 pins female• On compute side: D-sub 9 pi

29CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Power SupplySpecificationsCabling • Camera connector type: Hirose HR10A-7R-6PB (male)• Ca

3CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Figure 1. LVDS Imaging SystemFigure 2. CameraLink Imaging System

30CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Mechanical InterfaceLVDS Camera with F Mount RingFigure 18. With F Mount RingFRONT PANEL

31CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04LVDS Camera without F Mount RingFigure 19. Without F Mount RingFirst pixelFirst line114

32CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04CameraLink Camera with F Mount RingFigure 20. With F Mount RingFRONT PANELREAR PANELFirs

33CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04CameraLink Camera without F Mount RingFigure 21. Without F Mount RingFirst pixelFirst li

34CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Mechanical Mounting References• Position in the X and Y plan:– The center pixel of the CC

35CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Standard Conformity The cameras have been tested with the following equipment:• Complete

36CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Revision HistoryVersion Number Description5319C M = 3 command for 8-bit output format 531

Printed on recycled paper.Disclaimer: Atmel Corporation makes no warranty for the use of its products, other than those expressly contained in the Co

4CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04The Camelia camera is powered by a single 24V power supply. It is configurable via thecomp

5CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04CCD DescriptionImage Format 35.0 mm (V) x 23.0 mm (H)Figure 3. Sensor OrganizationNote: T

6CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Camera SpecificationsLSB (Least Significant Bit): 12 bits correspond to 4095 LSB.Absolute

7CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Spectral Responsivity Figure 4. Spectral ResponsivityImage Grade Specification• Defect si

8CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04ClassificationsCCD Window Specification• Thickness = 1.2 mm ± 0.05• Glass index at 588 nm:

9CAMELIA M1 8M LVDS and CameraLinkTM Camera5319C–IMAGE–02/04Camera FeaturesRegions of Interest(ROI )Caution: This function has been available since Oc